PURE BEESWAX CHURCH PILLAR CANDLE
FROM 101 MM UP TO 914 MM TALL BY 75 MM WIDE PURE NATURAL BEESWAX CHURCH CANDLES.
From 4 inches up to 36 inches tall by 3 inches wide beeswax church candles made from pure beeswax
- Beeswax has a long burning time and burns with a bright golden flame and is drip free
- Our church candles are approximately 75 mm wide.
- Our beeswax church candles are made here in Cornwall and not in the far east or mainland Europe.
- Our beeswax church candles are only available on Cornish Candles website
Burn the candles for at least 4 hours so that the melt pool of wax will reach the edge of the candle. If you only burn it for an hour it will not reach the edge and will tunnel down in the centre of the candle and not burn correctly.
As the candle burns occasionally you will need to carefully press the edges at the top of the candle towards the centre of the candle to make sure that all of the wax burns properly. This will stop the candle tunnelling down and give you a even burn, do this after the candle has been put out
Keep the wick trimmed to about 1cm or just below that as if the wick is to long it will cause the candle to smoke. I recommend that you light your candle and let it burn for a few minutes and then check to see if the flame is tall or flickering. If it is trim a little bit off the wick at a time with a pair of scissors then relight the candle, you may have to repeat this a couple of times in the first hour of burning but after that once an hour should be okay.
Burn the candles in a draught free position, away from windows, doors, fans ETC otherwise a draught can make a candle smoke and burn unevenly.